TROUBLESHOOTING GUIDE

If you have followed the instructions contained in this manual and have difficulty in operating your VCR, locate the PROBLEM in the left column below. Check the corresponding CORRECTIVE ACTION columns to remedy the problem.

PROBLEM

CORRECTIVE ACTION

 

 

No power.

• Make sure the AC cord is connected to an AC outlet.

 

• Make sure the power is turned on.

 

 

Timer recording is not possible.

• Make sure the timer recording is set correctly.

 

• Make sure the power is off.

 

• Make sure the VCR clock is set correctly.

 

 

Cannot go into Record mode.

• Make sure the tape has an erase-prevention tab. If needed, cover

 

the hole with plastic tape.

 

 

Playback picture is partially noisy

• Adjust tracking control for a better picture by using the CHANNEL

 

or

button on the VCR.

 

 

No picture but the audio is OK in playback.

• Head cleaning may be necessary. Refer to "HEAD CLEANING" on

 

 

page 37.

 

 

No picture or poor picture on playback.

• Set your TV to the VCR mode and/or press the VCR/TV button on

 

the remote control so that the "VCR" indicator on the display comes

 

 

on.

 

• Fine tune your TV.

 

 

On-the-air TV programs cannot be seen.

• Re-check the ANT. IN and ANT.OUT connections. See page 10.

 

• Set your TV to the TV mode and/or press the VCR/TV button on the

 

remote control so that the "VCR" indicator on the display disappears..

 

 

No operation from the infrared

• Make sure the AC cord is connected to an AC outlet.

Remote Control

• Check batteries in remote control

 

• If the TV or CATV button is selected, press the VCR button on the

 

 

remote control

 

 

Video or color fades in and out when

• You cannot copy a copyrighted video tape. You are experiencing

making a copy of a video tape

copy guard protection.

 

 

 

MAINTENANCE

SERVICING

Should your VCR become inoperative, do not try to correct the problem by yourself. There are no user- serviceable parts inside. Turn off, unplug the power cord, and take the unit to our Authorized Service Center for servicing.

CABINET CLEANING

•Wipe the front panel and other exterior surfaces of the VCR with a soft cloth immersed in lukewarm water and wrung dry.

•Never use a solvent or alcohol. Do not spray insecticide liquid near the VCR. Such chemicals may cause damage and discoloration to the exposed surfaces.

HEAD CLEANING

•Playback picture may become blurred or interrupted while the TV program reception is clear. Dirt accumulated on the video heads after long periods of use, or the usage of rental or worn tapes can cause this problem.

If a streaky or snowy picture appears during playback, the video heads in your VCR may need to be cleaned.

1. Please visit your local Audio/Video store and purchase a good quality VHS Video Head Cleaner.

2. If a Video Head Cleaner does not solve the problem, consult our nearest Authorized Service Center. Professional video head cleaning requires highly technical attention.

NOTES:

•Remember to read the instructions included with the video head cleaner before use.

•Clean video heads only when problems occur.

44