English
Taper shank
Cotter adaptor
Fig. 11
CAUTION:
When the warming up operation is performed, hold the side handle and the main body securely with both hands to maintain a secure grip and be careful not to twist your body by the jammed drill bit.
7.How to use the drill bit (taper shank) and the taper shank adaptor.
(1)Install drill bit with taper shank in the taper shank adaptor. (Fig. 12)
Taper shank adaptor
Drill bit (Taper shank)
Support
Fig. 13
USING DRILL CHUCK, CHUCK ADAPTOR
Note that this machine can be used at “rotation only” if separately sold parts such as drill chuck and chuck adaptor are attached. Use it with the selector lever positioned at “rotation + hammering”.
WARNING:
During operation, be sure to grip the handle and the side handle firmly to prevent your body from swaying.
(1)Switching to “rotation + hammering”
For switching to “rotation + hammering”, follow the same procedures mentioned in [3. When drilling at “rotation + hammering”] in Page 8.
(2)Attaching chuck adaptor to drill chuck (Fig. 14)
(a)Attach the chuck adaptor to the drill chuck.
(b)The SDS max shank of the chuck adaptor is equivalent to the drill bit. Therefore, follow the same procedure as [6. How to install tool] in Page 7 for attaching and detaching.
Fig. 12
(2)Turn the power on and drill a base hole.
(3)After cleaning out dust with a syringe, attach the plug to the anchor tip and drive in the anchor with a manual hammer.
(4)To remove the drill bit with taper shank, insert a cotter into the slot of the taper shank adaptor, place supports under the Rotary Hammer and tap the cotter with a manual hammer. (Fig. 13)
Drill | SDS max |
|
chuck | shank | Grip |
Chuck |
|
|
adaptor |
|
|
Fig. 14
(3)Drilling
(a)Even if you apply
10