Hobart CE10FD Specifications, Details And Dimensions, Page 2 of, Model, Width, Depth, Height

CE10FD BOILERLESS FULL SIZE COMBI OVEN

701 S Ridge Avenue, Troy, OH 45374

1-888-4HOBART • www.hobartcorp.com

SPECIFICATIONS:

General: Hobart Combi Oven, Electric, Boilerless, 10 level full size combi.

Construction: All stainless steel interior and exterior, top, rear, sides, and bottom are fully insulated. All welded stainless steel cooking compartment. Stainless steel oven door features a large curved outer glass with enhanced insulation for a cool to touch exterior, with full length hinged floating inner glass panel. A full perimeter door gasket with drip tray inside door and oven frame. Door opens right to left and swings a full 180 degrees. Standard with rack guides and (5) wire racks. Built in wash arm for automatic cleaning with auto dosing pump, 4-speed auto reversing fan,

(3)halogen flashing door lights, core probe, dual point door latch

connection­ for a full perimeter sealed connection. Standard with 1.6" feet for stand connection.

Controls: Simple, user friendly digital controls on the right with large indicative low voltage LCD display - for easy cleaning and operating pleasure. Manual operation or programmable up to

100 recipes with 10 cooking phases each. Includes Bluetooth®

communication­and recipe software for PC.

Operation: Electric boilerless combi which uses a direct steam creation method. Hobart’s Boilerless Combi uses optimized cooking

functions for maximum production­ with minimal energy and water consumption.

Water: A suitable Hobart Water Treatment System is the recom- mended minimum to meet the water quality spec. ¾" NSHT cold

water, 30-60 psi and 1" NPT drain connection­ .

Capacity: Capable of holding: (20) 12" x 20" x 21⁄2" steam table pans or (10) 18" x 26" sheet pans or (20) 13" x 18" x 1".

DETAILS AND DIMENSIONS:
								LEGEND:
	Model	Width		Depth	Height	Weight	1.		ELECTRICAL
	CE10FD	35.4"	45.0"		36.8"	437 lbs.	2.		DRAIN
							3.		ALTERNATE DRAIN
								4. WATER SUPPLY

User Responsibility: The product must be installed, cleaned and maintained as described in the Manual furnished with the product.

Water Quality Specification for Warranty Purposes

The fact that a water supply is potable is no guarantee that it is suitable for steam generation. All steam equipment is subject to contamination and failure due to chemical and mineral content found in water. A suitable Hobart Water Treatment System and regular filter replacements coupled with routine deliming is the recommended minimum. Damage as a result of poor water quality or lack of required owner/operator maintenance is the responsibil- ity of the owner/operator.

Your water supply must be within these general guidelines:

DYNAMIC WATER PRESSURE	30-60 psig
HARDNESS *	less than 3 grains
SILICA	less than 13 ppm
TOTAL CHLORIDE	less than 30 ppm
Ph RANGE	7-8
CHLORINE & CHLORAMINE	0 ppm
ALKALINITY	Less than 20 ppm
TDS	Less than 60 ppm
UN-DISSOLVED SOLIDS	less than 5 microns
* 17.1 ppm = 1 grain of hardness

Clearance: Left 1", Back 2", Right 2" required, 18" recommended for service access.

Model	Voltage	Amps	Watts	Fuse*
		(max used)		(amps)
CE10FD-1	208/60/3	59.4	21400	80
CE10FD-3	230-240/60/3	53.6-58.4	21400-23300	80
CE10FD-2	480/60/3	26	21400	35

NOTES:

Amperage values in the table are nominal. Tolerance is +5/-10%.

Convection heater currents must be measured in full power convection heat mode. Steam generator heater currents must be measured in full power steam mode.

* Recommended size. Always refer to the NEC, state and local codes.

Other factors affecting steam generation are iron content, amount of chlorination and dissolved gasses. Water supplies vary from state to state and from locations within a state. Therefore it is ­necessary that the local water treatment specialist be consulted before the installation of any steam generating equipment.

Note:

•Installation of backflow preventers, vacuum breakers and other specific code requirements is the responsibility of the owner and installer in compliance with local codes.

•Plastic drains are not recommended due to inherent limited temperatures of the plastic. The installer may be required to provide means to reduce water drain temperature to be that of the condensate temperature of 140°F or less.

NOTICE: Fluorescent lamp in display panel contains a small amount of ­mercury. Please dispose of according to local, state or federal laws.

As continued product improvement is a policy of Hobart, specifications are subject to change without notice.

Page 2 of 2	F-40175 – CE10FD Boilerless Full Size Combi Oven
F-40175 (REV. 06/11)	LITHO IN U.S.A. (H-01)