F33995 (Rev. A, 6/06) Page 10 of 12 © HOBART 2006
Cleaning and Maintaining Maintain the SLA by regularly cleaning the paper dust from
inside the unit. Clean the SLA exterior surfaces with a cloth and
warm water/detergent solution. When cleaning, be sure to
protect the unit from direct water entry.
To clean the SLA:
1. Dampen a soft cloth with mild detergent and water.
2. Wipe the exterior surfaces.
Note
Remove any adhered labels with an alcohol soaked cloth. Do
not use metal to scrape the labels or adhesive off of the unit.
DISPLAY PROMPTS POSSIBLE CAUSES/REMIDIES
1. Out of security labels. Load security
labels or press escape to continue.
2. Verify labels threaded correctly.
3. SLA power switch is OFF.
4. Check power cord and power source.
5. Call local Hobart Office.
SYMPTOMS POSSIBLE CAUSES/REMIDIES
Power ON indicator is not illuminated and unit will
not function.
1. SLA power switch is OFF.
2. Check power cord and power source.
3. Call local Hobart Office.
Power ON indicator is illuminated and will not
issue label (motor does not run).
1. Call local Hobart Office.
Issue label only when manual eject button is
pressed.
1. Minimum Unit Price or minimum Total
Price is set too high in the Security label
setup and/or apply by PLU is not
configured correctly in Change Product
screen in Supervisor.
2. Call local Hobart office.
Label does not peel off of backing paper.
1. Verify labels threaded correctly.
2. Call local Hobart office.