SECTION 7 − MAINTENANCE &TROUBLESHOOTING
7-1. Routine Maintenance
Y Disconnect power before maintaining.
3 Months
Replace unreadable labels.
Repair or replace cracked weld cable.
Clean and tighten weld terminals.
6 Months
Blow out or vacuum inside.
During heavyOr service, clean
monthly.
7-2. Overload Protection
1
1 Circuit Breaker CB1
CB1 protects unit from overload. If CB1 opens, unit shuts down.
Reset breaker.
802 441
7-3. Drive Motor Protection
Drive motor protection circuit protects drive motor from overload. If drive motor becomes inoperative, release gun trigger and wait until protection circuit resets allowing drive motor to feed wire again.
