Hobie V2 Drum manual Vise method

3

Vise method:

3 B. Secure Drive to vise by rear portion as shown. Use a rag in vise to prevent marks (rag removed for illustration purposes, right).

4 B. Mount both drum / crank arm assemblies to drum shaft, noting correct left and right side.

5 B. Mount the rear sprocket cable. Note, the cable is first inserted from the side, with the help of needle nose pliers if necessary, then re-routed over the top lip of the drum. Hand thread Nyloc nuts enough to keep the cable from slipping

out (below).

6

B. Repeat procedure with the front sprocket cable.

7 B. Insert idler cable into lower rear drum hole as shown. Note, the idler slot is divided -- use the outboard portion only (right).