OPERATING INSTRUCTIONS
Step 1: Set the fan base on a dry, level surface.
Step 2: Please make sure the speed control knob is in the off posi- tion. Plug cord into any standard 120 volt A/C outlet.
Step 3: The SPEED is adjusted by moving the knob left or right to one of the 3 desired settings (High, Med., and Low).
Step 4: The OSCILLATION control knob is located on the top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up.
ADJUSTMENT INSTRUCTIONS
Tilt Adjustment:
Step 1: Loosen the
FIGURE 2
B
E
F
G H
CLEANING/MAINTENANCE INSTRUCTIONS
Follow these instructions to correctly and safely care for your Holmes table fan. Please remember:
•Always unplug the fan before cleaning or disassembling.
•Do not allow water to drip on or into the fan motor housing.
•Do not use any of the following as a cleaner: gasoline, thinner, or benzine.
Step 1: To access the fan blade, remove the front grill and then unscrew the securing screw on the fan blade.
Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution.
Step 3: Replace blade, tighten the fan blade by screwing the fan blade back on, and securely fasten the front grill.
Fan Head and Base Cleaning
Using a soft, moist cloth, with or without a mild soap solution, care- fully clean the fan base and head. Please use caution around the motor housing area. Do not allow the motor or other electrical com- ponents to be exposed to water.
FAN STORAGE
Your fan should be stored in the
• Remember to protect the fan head from dust or moisture.