PRE-OPERATING INSTRUCTIONS
NOTE: The door should not be opened when the unit is on its side.
1)After removing the unit from the box, take the plastic covering off the unit.
2)Place unit with air intake grill pointing up.
3)Open the door of the air purifier.
4)The Carbon filters, which are packed in a plastic bag in the box, should be removed from plastic bag and then placed on each of the HEPA filters. The plastic tabs on the HEPA filter will hold the carbon in place (fig. 1).
5)Close the air purifier door by pushing firmly against the right hand side of the door.
OPERATING INSTRUCTIONS
1)Select location where air intake grill and filtered air outlet are not obstructed.
2)Plug into a 120V AC electrical outlet.
3)The air purifier is now ready for your use. To turn the machine on press ON/OFF button. On will automatically cycle to the highest setting. Use the speed button to set your desired speed of high ( ), medium ( ) , low ( ) or
4)To shut the unit off simply press the ON/OFF button on the unit.
REMOTE CONTROL
Unit comes with a remote control. The HAP675RC can be controlled /operated by either the remote control handset or the manual push buttons on the unit. The remote control has (5)
(2) AAA batteries.
Figure 1 | B |
|
| Figure 2 | |
|
|
|
| A | C |
|
|
|
|
| |
A. | HEPA FILTER | Figure 3 |
| E | |
B. | CARBON FILTER |
| |||
|
| ||||
C. | HANG TABS |
|
|
| |
D. | AIR INLET GRILL | D |
| F | |
E. | FILTERED AIR |
|
| G | |
| OUTLET |
|
|
| |
F. | SPEED CONTROL |
|
| H | |
| ON/OFF BUTTONS |
|
|
| |
G. | FILTER LIFE |
|
|
| |
| INDICATOR |
|
|
| |
H. | RESET |
| J |
| I |
I. | POWER CORD |
| |||
|
| ||||
| (not shown) |
|
|
|
J.SPEED INDICATOR
CLEANING AND MAINTENANCE INSTRUCTIONS
1)Turn the air purifier off and unplug it before cleaning.
2)The outside of the air purifier can be cleaned with a soft, clean, dampened cloth.
3)The filtered air outlet on the top of the unit can be cleaned of dust with a small, soft brush.
4)If you wish to clean the inside of the air purifier, please remove filters and only use a dry, soft cloth to wipe it down.
5)Do not wash filters.
FILTER REPLACEMENT INSTRUCTIONS:
1)On average, HEPA filters need to be replaced every
2)Turn off and unplug the air purifier before attempting to replace the filters.
3)Remove each of the filters from the unit by pulling gently towards you.
4)To replace the carbon filter, simply remove the old carbon filter and insert a new carbon in its place, using the plastic tabs as a guideline (see Figure 1).
5)To replace the HEPA filter, discard the old HEPA filters. Do not attempt to clean. Put the carbon filter back on the HEPA filter. Insert the new HAPF600 HEPA filter into the unit, by sliding it onto the hang tabs.
6)After replacing the HEPA filters, RESET the Filter Life Indicator by inserting a small object (such as a pin or paper clip) into the hole below the red filter change light marked reset.
Replacement filters are as follows:
HAPF600 HEPA Filter, HAPF600D HEPA Filter (2 pack) HAPF60 Carbon Filter
These filters can be purchased at a retailer near you or by calling
NOTE: Carbon and HEPA Filters are not washable
TROUBLESHOOTING
PROBLEM | SOLUTION |
| |
Unit will not operate | • | Check to make sure the unit is |
|
| • | plugged in. |
|
| Check to make sure the unit is on |
| |
|
| by pressing the ON/OFF button. |
|
| • If the door is ajar the unit will not |
| |
|
| operate. Make sure the filters are |
|
|
| properly installed and firmly close |
|
|
| the door. |
|
Decreased air flow | • | If the Filter Life Indicator is red, |
|
| • | the HEPA filters need to be changed. | |
| If the filters have not been changed | ||
|
| in a year or more, change the |
|
| • | HEPA filters. |
|
| Check to ensure nothing is blocking | ||
| • | air inlet and filtered air outlet. |
|
| Ensure carbon filters are changed |
| |
|
| every | Page 3 |
|
|
|