Holmes HASF1933 warranty Illustration, Adjustment Instructions, Cleaning/Maintenance, FAN Storage

ILLUSTRATION

				M	N
					O
A				K	P
	F	G	H
				L
B
	D E		I
C				Q	R
A. Grill Hub				J
B. Screw					S
C. Washer
D. Grill Ring					T
E. Front Grill
F. Blade Nut
G. Blade
H. Rear Grill Mounting-Nut					U

I.Rear Grill

J.Metal Plate

K.Motor Shaft

L. Motor Housing Prong	V
M. Handle	W
N. Oscillation Knob

O.Motor Housing

P.Upper Pole

Q.Speed Control Lever

R.Upper Pole Nut

S.Adjustable Height Nut

T.Extension Pole

U.Lower Pole

V.Stand Lock

W.Foot Extension (4)

ADJUSTMENT INSTRUCTIONS

Tilt Adjustment

To change the tilting angle of the fan head, move the fan head to the desired angle.

Height Adjustment

Loosen the adjustable height nut and slide the fan up or down to the desired position and then tighten the nut.

WARNING: MAKE SURE TO SUPPORT THE FAN HEAD ASSEMBLY WHEN LOOSENING THE ADJUSTABLE HEIGHT NUT, AS THE WEIGHT OF THE FAN HEAD MAY CAUSE THE EXTENSION POLE TO COLLAPSE.

CLEANING/MAINTENANCE

Follow these instructions to correctly and safely care for your Holmes stand fan. Please remember:

•Always unplug the fan before cleaning or disassembling.

•Do not allow water to drip on or into the fan motor housing.

•Do not use any of the following as a cleaner: gasoline, thinner, benzine

(See instructions for fan head assembly)

Step 1: To access the fan blade, remove the front grill and the fan blade nut.

Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution.

Step 3: Replace blade, tighten the fan blade nut, and securely fasten the front grill.

Fan Head, Base, and Pole Cleaning

Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base, pole, and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.

OPERATING INSTRUCTIONS

Step 1: Set the fan base on a dry, level surface.

Step 2: Please make sure the On/Speed lever is in the "Off" position. Plug the cord into any standard 120-volt A/C outlet.

Step 3: The SPEED is adjusted by moving the lever up or down to the desired setting.

Step 4: The OSCILLATION control knob is located on the top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up

FAN STORAGE

Your fan can be stored in the off-season either partially disassembled or assembled. It is important to keep it in a safe, dry location.

•If stored disassembled, we recommend using the original (or appro- priately sized) box.

•If stored assembled or partially assembled, remember to protect the fan head from dust.