F E AT U R E S - O P E R AT I O N S
Step 3: Place the base nut on the threaded section and
Step 4: Insert the other pole with the threaded joint (male end) into the hollow end of the lower pole (female end), until both poles meet. Be careful to align the cutaway / grooves on the threaded joint (male end) with the two protruding pieces inside the hollow end of the lower pole (female end).
Step 5: Turn the upper pole clockwise to lock it securely in place.
Final Assembly
Step 1: Insert the neck of the fan head into the hollow end of the pole and turn the neck clockwise to lock into place.
OPERATING INSTRUCTIONS
Step 1: Set the fan base on a dry, level surface.
Step 2: Please make sure the On/Speed knob is in the "Off" or "0" position. Plug the cord into any standard
Step 3: The SPEED is adjusted by moving the knob left or right to the desired setting.
Step 4: The OSCILLATION control knob is located on the top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up.
ADJUSTMENT INSTRUCTIONS
Height Adjustment
This fan is equipped with two poles, which allow you to adjust the height of the fan for three height settings.
Tilt Adjustment
To change the tilting angle of the fan head, move the fan head to the desired angle.
CLEANING/MAINTENANCE
Follow these instructions to correctly and safely care for your Holmes Power Stand Fan. Please remember:
•Always unplug the fan before cleaning or disassembling.
•Do not allow water to drip on or into the fan motor housing.
•Do not use any of the following as a cleaner: gasoline, thinner, benzine.
•We also recommend the periodic cleaning of this fan by lightly running a vacuum cleaner nozzle over the fan grill to remove any dust or dirt that may have accumulated inside or on the unit
FAN STORAGE
Your fan can be stored in the
•If stored disassembled, we recommend using the original (or appropriately sized) box.
•If stored assembled or partially assembled, remember to protect the fan head from dust.
