F E A T U R E S - O P E R A T I O N
HOW COOL MIST WORKS
Your Holmes Cool Mist humidifier draws dry air through the rear air intake grill area. This air is then passed through a
NOTE: This humidification system provides a cool, invisible moisture output. It is normal not to see the mist.
NOTE: A humidity level below 20% can be unhealthy and uncomfortable. The recommended humidity level is between
Figure 1 | WHEEL INSTALLATION |
A | A. STATIONARY WHEELS |
| B. SWIVEL WHEELS |
| C. |
| HUMIDIFIER BASE |
B | C |
PRE-OPERATING INSTRUCTIONS
1. | Be sure the humidifier is switched OFF and the unit is disconnected |
| from the electrical outlet. |
2. | Remove humidifier base, filter and tanks. |
3. | TO PROVIDE ADDITIONAL MOBILITY AND CONVENIENCE TO YOUR CONSOLE |
| HUMIDIFIER, install the wheels. Remove the four wheels located in a small |
| pouch in the box. Turn the base upside down, and locate the holes at each |
| of the four corners on the underside. |
| Note: You will notice that there are two different shaped wheels. Two |
| of the 4 wheels are stationary wheels and two are swivel type wheels. |
| The stationary wheels are identified by a flat top surface, while the swivel |
| type are curved and include a small plastic piece on the shaft. See figure |
| 1 for installation location for each type of wheel. DO NOT use any tools |
| to install the wheel because tools may damage the base of the unit. |
| Return the base to the upright position. |
4. | Replace filter, base and tanks. |
OPERATING INSTRUCTIONS
1.The unit display will turn on when you plug the power cord into the electrical outlet.
2.Once the unit is plugged in the digital display will show the current room humidity (on the left of the display) and the last set humidity level (on the right of the display).
3.To turn the humidifier on press the power button once. To adjust the humidifier speed, press the MODE button. The humidifier will start at HI then go to MEDIUM, LO and then the AUTO speeds (HI, MEDIUM, LO). The humidifier will start in the last set speed unless the humidifier has been unplugged.
Note: If condensation forms on your windows or walls, or your humidity % on your display reads above 50% then turn the unit off.
When the tank runs out of water push the POWER button OFF and unplug. Remove and refill the water tank being sure to follow the Daily maintenance instructions. Replace the tank into the base.
NOTE: If moisture forms on the walls or windows, turn off the humidifier.
SETTING THE ACCUSET, PROGRAMMABLE HUMIDISTAT:
Follow the Pre-operating instructions.
The programmable humidistat is designed to operate between 30% and 65% relative humidity range. The recommended setting is between 40% and 50%.
1.To program a
2.Once you have chosen your Auto speed, choose your humidity setting by pressing the SET HUMIDITY button. The SET HUMIDITY button works in multiples of 5, beginning with lowest setting, 30% and ending with highest setting, 65%. Choose the appropriate setting and your Accuset humidistat is now programmed.
NOTE: When the humidity level in the room is less than the humidity level you have programmed, the humidifier will continue to produce moisture. Once the room
5. Choose a location out of reach of children. DO NOT place the humidifier |
on a finished floor or near furniture which can be damaged by moisture |
or water. Place on a |
FILLING THE WATER TANK
1. Remove the two tanks from the base of the humidifier and bring each |
tank to the faucet. Turn the tanks upside down and twist off the tank |
caps by turning |
Figure 2
A. CIRCULAR EXTENDED LIFE FILTER
B. CIRCULAR FILTER SUPPORT
C. FLOAT SWITCH
A
| water. Replace the cap on each tank FIRMLY. |
2. | When full, carry each tank to the humidifier and place onto the base |
| (use both hands when carrying each tank). Each tank holds 1.6 |
| gallons of water, and the base holds .25 gallons of water. |
3. | Plug the power cord into the electrical outlet. |
D. HUMIDIFIER | B |
BASE
D
C
