Hooking Up the Wires
The terminals will accommodate up to
When connecting a speaker, it is very important to retain the correct polarity. To do this, be sure that the wire attached to the +, red, or positive terminal on the speaker connects to the +, red, or positive terminal on the other component. Similarly, the
Mounting the Speaker (if you are unsure, consult a professional contractor)
Yes, you will be cutting a hole in the wall or ceiling. With the right tools and a little extra care and preparation, installing the in- wall speaker can be both quick and easy. Carefully cut out the hole drawn on the cardboard template at the perforated edge labeled “CUT ALONG OUTSIDE RING FOR MOUNTING TEMPLATE”. (Note: the inside ring on the template can be used to shield the woofer while you paint the frame.) Next, position the template, now a border, where you have chosen to mount the speaker and trace along the inside edge. Make your cuts along this line. A utility knife will make the cleanest cuts in drywall. A keyhole saw or an electric jigsaw may also be used. Try to keep the cuts neat, however the frame will overlap the hole to hide any rough edges. With the wall open, run the speaker wires into position and leave about two feet of extra wire at the opening.
Remove the grille from the frame by pressing the
Installing the Grille
The metal grille, as well as the plastic frame, may be painted to match any room. If you choose to paint them, do so before attaching the grille to the speaker. The grille is held in place by a friction fit and is difficult to remove once the speaker is installed. If the grille feels a little loose, or you are concerned about a grille falling from a ceiling installation, we have provided a small amount of putty, which you can apply (sparingly) to the inside rim of the speaker before you insert the grille. The putty acts as an additional adhesive between the grille and the frame.
Warranty
All HTD speakers carry a
From all of us at Home Theater Direct, thank you for choosing HTD!
HTD-R3S Specifications
Frequency Response | 55 Hz to 20 kHz |
Power Capacity | 100 watts |
Impedance | 8 ohms |
Sensitivity | 90 dB |
Woofer | 8” polypropylene with butyl surround |
Tweeter | 1” |
Dimensions | 10 1/4" diameter x 4” depth |
Weight | 7 lbs |
Design and specifications are subject to change without notice.
www.HomeTheaterDirect.com | Printed in China |
Toll Free: | © 2001 Home Theater Direct, Inc. |