DWS-170-IB SP\ENG 10/12/04 11:32 AM Page 5
SETTING ALARM TIME
1.Hold the “CLEAR ” button for 3 seconds.
2.To select either first alarm (A1) or second alarm (A2) - Press “ + , - ” on back to toggle between selections. Press “CLEAR ” to confirm your selecton.
3.Set alarm time - Press “ + , - ” on the back of the unit to enter the desired Hr/ Min values. Press “CLEAR ” to confirm.
4.To view alarm time - Press “CLEAR ” button. Alarm time will display for 5 seconds and then resume to normal clock thereafter.
5.To select between alarm 1, alarm 2 or alarm off - Press “ + “ button on the back of the unit.
For Daily Alarm - The appropriate “ ” icon will appear in the upper left corner of the time display.
No Alarm - The “ ” icons will not be shown.
6.The home receiver will provide either a daily alarm, which last for 2 minutes or a snooze mode where the alarm will repeat every 10 minutes until manually cleared (see SNOOZE/LIGHT section below.)
7.To turn alarm off - Simply press any button under the LCD display.
SNOOZE/ LIGHT
1.Press the SNOOZE/LIGHT button for an extended backlight.
2.In snooze alarm mode, press this button to trigger a repetitive snooze alarm.
MIN/ MAX MEMORY SETTINGS
1.Press ”MIN/ MAX“ button to view the maximum values for 5 seconds. Press again to view the minimum values.
2.To clear the memory record, press “CLEAR ” while the respective values are displayed on screen.
TEMPERATURE TREND INDICATOR:
In the upper right hand corner of the home receiver LCD display, you will see one of 3 icons;
will indicate Rising Temperature readings if it changes more than 1 degree in an hour
will indicate Steady Temperature readings
will indicate Falling Temperatures if it is more than 1 degree in an hour.
4
TEMPERATURE/ HUMIDITY ALERT
Press “ALERT” to turn temperature & humidity alert on and off.
1.Hold “ALERT” button located on back of home receiver for 3 seconds to enter the alert setting mode. The indoor icon will flash.
2.Press “ +, - ” to select the between indoor temperature, indoor humidity or remote sensor channels to be alerted to. Press “ALERT” to confirm your selection. The Upper pointer and the value on the LCD display will flash, enter the desired upper limit with the
“ +, - ” buttons, press “ALERT” to confirm your selection and then go to the lower limit setting.
3.The Lower pointer and value will flash, enter the desired lower limit with “ +, - ” buttons, press “ALERT” to confirm and exit.
4.You may enter an alert setting for the indoor temp, indoor humidity and remote sensor temperature.
5.When the temperature hits the limit of your preset levels, the Upper/Lower pointers and the temperature of the respective channel (indoor or remote sensor) will flash and produce an audible alarm. Press any button on the home receiver to acknowledge and stop the alarm.
USING THE PROJECTION FEATURE
(Only when powered by adaptor.)
The projection feature will display the time and outdoor/ remote sensor temperature. The projected TIME is the same as shown on the base LCD display. The projected TEMPERATURE is same as the remote sensor. To turn the projection feature on, slide the projection switch on the back of the unit to the ON position.
NOTE: If the projection feature is off, you may press the SNOOZE button on top of the unit to trigger 5 seconds of projection.
1. To turn the projected information 180 degrees, press the
5
