6.Fill base with clean water. Add enough water so that the platform is submerged.
(See embossed line inside the fountain base that represents the water fill line.) (Fig. 6)
Figure 6
Platform
7.Attach the A/C adaptor jack to the base power cord. DO NOT plug into outlet at this time. (Fig. 1)
8.Set the fountain on a level, waterproof surface.
9.Plug the cord into 120V household outlet. The switch located on the power cord controls the fountain. If pump doesn't operate, rotate
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip Loop' (Fig. 7). This will prevent water from running down the cord into the electrical outlet.
Figure 7
Figure 8
PVC Tubing
Inserts Here
Back Plate
ImpellerHousing
Drip Loop | Pump Inlet |
Front Plate
Suction Feet
Flow
Control
Lever
6
Maintenance
• To clean the pump:
Unplug from electrical outlet. Remove it from the base of the fountain. Use a small brush or stream of water to remove any debris (Fig 8).
• To keep water clean:
Periodically change water and clean the product according to the water condition. Keeping the water clean prevents the water from becoming sticky and forming
• To clean off hard water deposits on the base:
Soak the container in a mixture of vinegar and water to clean and remove any mineral
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level to avoid shortening the life of the pump.
NOTE: Never let the pump run dry, as this will shorten the life of the pump.
• Fountain storage
Unplug the fountain from the electrical outlet, empty the water, and store fountain in a dry, cool place.
Troubleshooting
• If water of rainfall holes fails to flow:
Take off lid and remove cleaning pin. Stick the cleaning pin through holes several times. (Fig. 9) Then replace lid on top of the fountain.
• If water of rainfall holes fail to flow straight:
Turn off fountain, use absorbent cloth to dry off the top and bottom of rainfall holes. Turn on fountain. (Repeat if needed until water flows straight.)
• If the pump fails to operate, check the following:
Check the circuit breaker, or try a different outlet to make sure the pump is getting electrical power.
NOTE: Always disconnect from electrical outlet before handling the pump.
• If the pump gurgles, spews, or “burps”:
Check the water level to make sure the pump has enough water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the rate of evaporation; refill with water as needed.
Figure 9
Cleaning Pin |
7 |