HoMedics WRF-REL instruction manual Assembly and Instructions for Use

Figure 3

Figure 1 Assembly and Instructions for Use

	1. Unpack the product and place on a horizontal			Water Flow Dial
		surface on top of the waterproof black mat
		provided. Wipe off dust with a damp cloth.		Volume
	2.	Familiarize yourself with the pump. The pump
		speed is controlled by the dial located at the front		Dial
		of the pump. The speed is indicated by a “min”
		and “max” (Fig 1). At its highest speed level, the
		dial will cease to move any further. To decrease
		the pump speed, move the dial counter-clockwise
		toward the “min”sign. Similarly, at its lowest		Steel
		speed, the dial will cease to move any further.		Net
	3. Insert the plastic tubing into the pump. Place
		pump into fountain lower basin (Fig 2).
	4. Fill the lower basin with clean water. The water level
		should be approximately 1/2 an inch below the steel
		net (Fig 3). NOTE: Distilled water is
		recommended for easier maintenance.		FRONT VIEW
	5. Attach the A/C adaptor jack to the base power
		cord. DO NOT plug into outlet at this time. (Fig 2)	Figure 4
	6. Insert light & sound cord through hole in top basin
		and insert into plug on bottom of lid. Then screw	Light &
		housing clockwise until tight. (Fig 4)		L.E.D. Lights
			Sound Plug
Figure 2
Music Speaker		Sound Selection
Light		Water Flow Dial
Switch
Light & Sound				Cleaning Pin
		Lock
Cord
Lower Basin		Plastic Tubing		Locks
		Pump		Water Flow Dial
Base Power	On/Off Switch
Cord
		Adaptor
		BACK VIEW
		4		5

7.Tilt lid forward and line up the hooks of the lid with the square locks of the top basin. Then place flat onto fountain top and slide lock switch (Fig. 2) to hold securely in place.

8.Plug the power cord into a 120V household outlet. The fountain & sound machine are controlled by the switch on the power cord. To operate Rain Forest Fountain, turn on by rotating switch on cord (Fig. 2). If fountain doesn’t operate, rotate switch once to turn on and once more to turn off to reset. NOTE: Unit power must be “ON” in order for both the fountain and sound machine to operate.

9.To use light, flip switch on the back of the fountain lid (Fig 2). Light will con- tinuously change colors.

10.To adjust rainfall speed, turn the water flow dial (Fig 2) clockwise to increase the rainfall and counter-clockwise to decrease. When dial stops in counter-clockwise motion, rainfall will come to a stop.

11.To use sounds, turn volume dial (Fig 3) counter-clockwise to turn on. Then select your nature sound by pressing the sound button of your choice. Volume can be adjusted by turning the volume dial – counter- clockwise to increase volume and clockwise to decrease volume.

12.To Turn sounds off either:

a.Press the off button on the lid to retain your volume setting for the next use, or

b.Turn the volume dial clockwise until it clicks off.

13.Turn fountain & sound machine off by turning the switch on the power cord.

NOTE: Main power switch must be used to turn unit completely on or off.

-Fountain can be used independent of sound machine

-Sound Machine can be used with- out fountain water flowing, although pump will remain on unless main “on/off” switch is turned off.