Motor (Continued)
12.Place motor and fan guard into rear of heater shell. Carefully route motor wires through hole in shell (see Figure 10).
13.Insert three screws through heater shell and into fan guard. Tighten screws firmly.
14.Turn heater on its side to access opening in bottom of base. Connect green motor wire and green power cord wire to heater shell using ground screw (see Figure 6, page 11).
15.Attach blue, white, and yel- low wires to empty connec- tors on blue, white, and yel- low wire locations of termi- nal board.
16.Attach wire guard to shell with two screws (see Figure 6, page 11).
Fan
1. Remove fan and motor (see Motor, page 11, steps 1 through 6).
2a. If replacing fan, remove old fan and discard. Go to step 5 below.
2b. If cleaning fan, remove fan. Be careful not to damage the fan blade pitch.
3.Clean fan using soft cloth moistened with kerosene or solvent.
4.Dry fan thoroughly.
5.To replace fan, follow steps 11 through 16 above.
12
Hole in Shell for Motor Wires
Figure 10 - Replacing Motor and Fan Guard into Heater
101497
