OPERATION
Fig. 8
ADDING OIL
See Figures 9 and 10.
Use HOMELITE Bar and Chain Oil. It is designed for chains and chain oilers, and is formulated to perform over a wide temperature range with no dilution required. Chain saw should use approximately one tank of oil per tank of fuel.
Note: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the oil pump, bar, or chain.
1.Carefully pour the bar and chain oil into the tank.
2.Fill the oil tank every time you fuel the engine.
Fig. 9
Fig. 10
OPERATING THE CHAIN BRAKE
See Figures 10, 11 and 12.
Refer to “Safety” earlier in this manual for additional information.
Check the operating condition of the chain brake prior to each use.
1.Using the back of your left hand, engage the chain brake by pushing the chain brake lever/hand guard toward the bar while the chain is rotating rapidly.
2.Reset the chain brake back into the RUN position by grasping the top of the chain brake lever/hand guard and pull toward the front handle until you hear a click.
WARNING:
If the chain brake does not stop the chain immediately, take the saw to a Homelite Service Center for repair prior to use.
BRAKE POSITION
Fig. 11
RUN POSITION
Fig. 12
Page 11
