Page 15
Grass wraps around the attachment shaft and the trimmer head assembly
Cutting tall grass at ground level.
Retaining cap is hard to turn
Screw threads are dirty or dam- aged.
PROBLEM
TROUBLESHOOTING
| POSSIBLE CAUSE | SOLUTION | ||
|
|
|
| |
Line will not advance when tap | 1. Line is welded to itself. | 1. | Lubricate with Homelite silicone spray. | |
retaining cap | 2. | Not enough line on spool. | 2. | Install more line (Refer to “Replacing the |
| 3. | Line is worn too short. |
| Cutting Line” earlier in this manual). |
| 3. | Pull lines while alternately pressing down | ||
| 4. | Line is tangled on spool. | ||
|
| on and releasing spool retainer. | ||
|
|
|
| |
|
|
| 4. | Remove line from spool and rewind (Refer |
|
|
|
| to “Replacing the Cutting Line” earlier in |
|
|
|
| this manual). |
|
|
|
|
|
Clean threads and lubricate with grease. If no improvement, replace spool retainer.
Cut tall grass from the top down.