TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
Grass wraps round drive shaft housing and string head:
1.Cutting tall grass at ground level.
2.Operating trimmer at part throttle.
1.Cut tall grass from the top down.
2.Operate trimmer at full throttle.
Spool retainer hard to | Screw threads dirty or damaged. |
turn: |
|
Clean threads and lubricate with grease - if no improve- ment, replace spool retainer.
Oil drips from silencer: | 1. | Operating trimmer at |
|
| part throttle. |
| 2. | Check oil/fuel mixture. |
| 3. | Air filter dirty. |
| 4. | Carburettor requires |
|
| adjustment. |
1.Operate trimmer at full throttle.
2.Use fresh fuel and the correct
3.Clean air filter. Refer to “Replacing and Cleaning Air Filter” earlier in this manual.
4.Turn mixture needle clockwise 1/16 turn. See Figure 18.
NOTE: The carburettor adjustment needle(s) are equipped with plastic cap(s) which prevent anticlockwise rotation from the original factory adjustment. If your unit exhibits specific performance problem(s) where the Trouble Shoot- ing Section recommends a anticlockwise needle adjust- ment and no adjustments have been made since original purchase, the unit should be taken to a
IDLE SPEED
SCREW
MIXTURE
NEEDLE
Fig. 18
16