Honda Power Equipment HRB215SDA BLADE REMOVAL AND INSTALLATION

BLADE REMOVAL AND INSTALLATION
If you remove the blade(s) for sharpening or replacement, you will need
a torque wrench for installation. Wear heavy gloves to protect your
hands.
BLADE SHARPENING: To avoid weakening the blade(s), or causing
imbalance or poor cutting, the blade(s) should be sharpened by
trained staff at an authorized Honda servicing dealer.
BLADE REPLACEMENT: Use genuine Honda replacement blades or
their equivalent.
Blade Removal
1. Put the throttle lever in the FUEL VALVE OFF position to close the
fuel valve. Disconnect the spark plug cap, then tilt the mower to the
right side, so the carburetor side is up. This will help to prevent fuel
leakage and hard starting due to carburetor flooding.
2. Remove the two blade bolts with a 14 mm socket wrench. Use a
wooden block to prevent the blade(s) from turning when removing
the bolts.
3. Remove the blade(s) from the blade holder.
UPPER MULCHING BLADE
(standard for HRM215)
$
2
s
I
?
LOWER MULCHING BLADE
(standard for HRM215)
SPECIAL WASHER (2)
HIGH-LIFT BLADE
(standard for HRB215)
56