SET-UP41
4. Install the discharge chute using the three 6 mm Phillips-head
screws and 6 mm self-locking nuts. Make sure the screws go on
the inside and the nuts on the outside. Tighten the nuts securely:
HEX NUT TORQUE: 7 ft-lbs (10 N•m)
5. Lift the spark plug door and attach the spark plug wire to the spark
plug.
6. Remove any packing material from the side of the snowthrower.

Add Oil & Fuel

1. The snowthrower is shipped WITHOUT
OIL in the engine.
2. Add enough of the recommended oil
(page 25) to bring the oil level to the top
of the filler hole.
3. Add regular unleaded fuel to the fuel
tank. The fuel capacity is 0.3 US gallons
(1.3 liters). See pages 22 and 44.

Before Use

All operators of the snowthrower must read the SNOWTHROWER
SAFETY (page 4), CONTROLS & FEATURES (page 8), and BEFORE
OPERATION (page 11) before using the snowthrower.
PHILLIPS-HEAD
SCREW (3) 6 mm NUT (3)
PHILLIPS-HEAD
SCREW (3)
6 mm NUT (3)
CHUTE BASE CHUTE CORRECTLY
ASSEMBLED
UPPER LIMIT