INSTALLATION INSTRUCTIONS
1.HITCH PIVOT INSTALLATION RT5000 and H5013 Tractors:
The 16.1 mm diameter hitch pivots provided with the tractor must be replaced with 22.1 mm diameter pivots.
Pivot, 22.1 mm (2 required)
H/C 3502374; P/N
a.Remove the six 8 x 16 mm flange bolts from lower frame cover B, and remove cover B for access to the hitch pivot rear mounting holes.
It is not necessary to remove lower frame cover A.
b.Remove the three 8 mm flange bolts from each hitch pivot, and remove the pivots.
c.Install 22.1 mm diameter hitch pivots in the rear mounting holes, as shown, using the 8 mm flange bolts that were removed from the original hitch pivots.
Do not tighten the bolts until after the pivot
rod has been installed (see page 4). ’
d. Reinstall lower frame cover B, and tighten the 8 x 16 mm bolts securely.
H5518 Tractors:
To provide clearance for the
a. Remove the two 10 x 20 mm flange bolts from the front edge of lower frame cover A. Remove the collars from the bolts.
b. Reinstall the 10 x 20 mm flange bolts without the collars. Tighten the bolts to a torque value of 39 N’m (29 f&lb).
1NOTICE 1
Do not operate the tractor with lower frame
cover A removed or unbolted. Lower frame cover A is a structural member that strengthens the frame.
FLANGE BOLT, 8 x 16 rnn! (6) | HITCH PIVOT, | 22.1 mm |
[Must be installed | in rear mounting hole.] |
COLLAR (2)
LOWER | FRAME | COVER B | \ |
| |
|
|
| ~~~A~10x20mmFlANGEBOLT(2) |
| |
[RT5000 | & H5013: | Temporarily |
| [5518: Remove collar | and reinstall bolt.] |
| Tightening torque: 39 | N’m (29 | |||
remove | to replace | hitch pivots.] |
|
3