Honda Power Equipment WT20XK4AC, WT40X

SERVICING YOUR PUMP

Installation:

VOLUTECASE

PUMPCASING

PUMP COVER WRENCH

DRAIN PLUG

KNOBS(4)

O-RING

Install the drain plug in the pump cover.

After tightening the pump cover knobs, check the pump cover and

pump casing to ensure that there is no water leakage.

Install the O-ring on the pump cover, taking care not to damage the

O-ring.

Install the pump cover on the pump casing, and tighten the knobs

hand tight. Then, set the wrench to the knobs and finish tightening

the knobs evenly.

02/01/14 13:24:07 31YG0600_041

Contents

Main Page INTRODUCTION 2 INTRODUCTION PUMP SAFETY IMPORTANT SAFETY INFORMATION CONTENTS 4 CONTENTS PUMP SAFETY Page Page CONTROLS & FEATURES COMPONENT & CONTROL LOCATIONS WT20X Page Page Page BEFORE OPERATION 13 BEFORE OPERATION 14 BEFORE OPERATION OPERATION IMPORTANT SAFETY INFORMATION BEFORE OPERATION head Page Page Page Page Page Page Page SERVICING YOUR PUMP Page MAINTENANCE SCHEDULE Replace the paper element type only. (2) (1) (3) Page Page Page Page Page Page Maintenance Schedule Page Incorrect spark plugs can cause engine damage. Page Page Page Page Page STORAGE Distributors Limited Warranty Page Draining the Fuel Tank and Carburetor Page BEFORE OPERATION Page ENGINE TAKING CARE OF UNEXPECTED PROBLEMS 49 TAKING CARE OF UNEXPECTED PROBLEMS TECHNICAL & CONSUMER INFORMATION Page The U.S. and California Clean Air Acts Tampering and Altering Source of Emissions Problems That May Affect Emissions Replacement Parts Maintenance Specifications WT20X WT30X WT40X