Reading Techniques
The view finder projects an aiming beam that should be centered over the bar code, but it can be positioned in any direction for a good read.
Hold the scanner over the bar code, pull the trigger, and center the aiming beam on the bar code.
The aiming beam is smaller when
the scanner is closer to the code and larger when it is farther from the code. Hold the scanner close to smaller bar codes, and farther away from large bar codes to get a proper read.
If the bar code is highly reflective (e.g., laminated), you may need to tilt the scanner at an angle so the bar code can be scanned.
Note: If the scanner beeps 3 times when scanning a bar code, the link has not been established. If the scanner beeps once, the link has been established.
Standard Product Defaults
The following bar code resets all standard product default settings.
Standard Product Defaults