Honeywell manual About the 5804BDV, Operating the Buttons, System Status Indications Table

K3636V3 9/04 Rev. A

ADEMCO 5804BDV

TWO-WAY WIRELESS KEY with VOICE STATUS

USER GUIDE

About the 5804BDV

The 5804BDV is a four-button remote control for your alarm system. It can send a command to the alarm system, such as to arm or disarm, as well as receive system status. Two LEDs and a speaker indicate system status. The 5804BDV is typically used for arming, disarming, and home automation. Check with your installer to understand which functions the buttons have been assigned on your unit.

Operating the Buttons

Activating a Function

To activate a function, press and hold the appropriate button down until the yellow LED flashes, and then release it.

Requesting System Status

You can check system status before arming or disarming your system.

Check your system status by momentarily pressing and releasing any button. The yellow LED will flash after you release the button. After a second or two, the 5804BDV will display the system status through the LEDs and speaker (see the System Status Indications Table, below). If the 5804BDV does not receive system status from the panel for approximately 5 seconds, it will shut itself down. It will also shut itself down if you do not press a button within 5 seconds of receiving a status update.

System Status Indications Table

	LED	LED Condition		Speech	System Status
Red		On Steady		System Armed Away	Armed Away or Maximum
				System Armed Stay	Armed Stay or Instant
		Flashing		Fire Fire Zone (Faulted Zone)	Fire Alarm in progress
				Alarm Alarm Zone (Faulted Zone)	Armed, Burglary Alarm in progress
				Alarm Alarm Zone (Faulted Zone)	Alarm Memory
Green		On Steady		System Disarmed Ready To Arm	Disarmed, Ready to Arm
		Flashing		System Disarmed Not Ready To Arm	System Not Ready, Zones Faulted
Yellow (right)		Flashing		—	Indicates RF transmission
Red & Green		Alternately		—	In Enter House ID Mode
		Flashing			In Set Volume Level Mode
NA		NA		System AC Loss	AC Loss Condition
				Low Battery	Low Battery Condition
Multiple Button Operations
	!			A + C Button Pair		B + D Button Pair
		The 5804BDV should not be used
WARNING!		for silent panic operation.
The 5804BDV can generate the same responses as keypad panic
key pairs of [*] + [#] and [*] + [1]			by depressing “A” + “C” and “B” +
“D” button pairs, respectively. You must depress the button pair
for at least 2 seconds for the 5804BDV to recognize the button pair
command. These button pairs			allow you to activate panic, fire,

5804BDV-005-V0

and medical alarms depending on control panel programming.

Adjusting the Volume Level

To enter the Volume Level mode, press and hold down the A, B, and D buttons at the same time until the unit’s red and green LEDs flash alternately. If no button is pressed within 5 seconds, the unit will automatically shut down and no change to the volume level is made. Press the A button for low volume level, the B button for mid volume level, and the C button for maximum volume level. You will hear the word “Alarm” at the selected volume. Then press the D button to accept the selected sound level. Note that volume level affects the life of the battery. Use low volume for maximum battery life.