F111 (SERIES 1,2) IN CEILING MEDIA AIR CLEANER
IMPORTANT
Do not touch the pleated filter media. Handle only the filter frame to prevent damage to the filter media.
7.Close and latch the lid.
CPZ™ Adsorbent Module
The CPZ™ adsorbent module is used to collect gases, vapors, odors and volatile organic compounds (V.O.C.) from the air that passes through the air cleaner. Adsorbents collect and hold 25% to 50% of their weight in odorous gases and vapors. The impurities are collected until the adsorbents reach saturation. At saturation, the adsorbents emit a continuous strong pungent odor. If the air cleaner is turned off for 8 to 10 hours, there will a temporary odor when it is turned back on. If the odor persists for 30 minutes, it is time to replace the filters.
NOTE: When tobacco smoke is a contaminant, both the particle filter and the adsorbent filter will need to be serviced at the same time.
1.Slowly open the lid, supporting the lid so the filters do not fall out.
2.For Series 1 only.Support the adsorbent module with one hand and release the fastener.
3.For Series 2 only.Support the adsorbent module with one hand and turn open the catches
4.Use two hands and slide the filter from the housing.
IMPORTANT
The module weighs about 26 lb (12 kg) and can be hard to handle.
5.Place the spent module in a plastic trash bag and dispose of properly.
6.Remove CPZ™ sorbent modules from their packaging and install. Be sure the fastener tabs (3) are facing downward and fastened.
7.For Series 1 only. Be sure the fastener tabs are facing downward and fasten them.
8.For Series 2 only.Be sure both catches are turned down and filter rests firmly on catches.
9.Close and latch the lid.
NOTE: On initial startup, a small amount of dust can blow from the air cleaner. This is normal and stops a few minutes after startup. The
7 |
