Honeywell F300 Reassemble Air Cleaner, Complete Wiring

F300 ELECTRONIC AIR CLEANER

68-0240EF-5 10

Reassemble Air Cleaner

!Insert the electronic cells with the gray contact board toward

the power supply and the airflow arrow pointing

downstream. If the cell does not slide easily into the cabinet,

check the orientation of the cell key.

!Insert the metal mesh prefilters on the upstream side of the

cabinet in the guide provided.

!Insert the media postfilters (on select models) on the

downstream side of the cabinet in the guide provided.

!Replace the access door. Insert the tab on the bottom of the

door into the slot in the cabinet, then swing it closed and

press into place. The door must be firmly in place or the air

cleaner will not operate.

Complete Wiring

WARNING

Electric Shock Hazard.

Can cause personal injury.

Do not use an extension cord.

• Assure all wiring complies with local codes and ordinances.

• The line voltage power source must match the voltage and

frequency printed on the label inside the access door.

• When the System fan comes on, the Air Flow Switch (AFS)

senses the negative pressure in the duct and turns on the

power supply. If power to the air cleaner is controlled by

another switch, the AFS can be disabled by disconnecting

the AFS plug J3 and cutting the J8 jumper on the power

supply. See Fig. 10.

!Plug the electronic air cleaner directly into the correct

voltage and frequency outlet. See Fig. 10 for internal

schematic. The air cleaner operates correctly with any fan

when wired with conduit or plugged in.

NOTE: To reduce the risk of electric shock, this product has a

grounding type plug that has a third (grounding) pin.

This plug only fits into a grounding type power outlet.

If the plug does not fit into the outlet, contact a quali-

fied electrician to install the proper outlet. Do not

change the plug in any way.

!Alternatively, the electronic air cleaner can be wired with

conduit.

Fig. 10. Internal schematic for electronic air cleaner.

P3

P4

P1

P2

J3

BLACK

W4 W2 W1 W3

AIRFLOW SWITCH BOARD

ORANGE

GRAY

VIOLET

BLACK

1 INTERLOCK SWITCH.

2 SHORTING BAR FOR OZONE REDUCTION.

3 AIRFLOW SWITCH DISABLE JUMPER, J8.

AIRFLOW SWITCH PLUG, J3.

4 NEON LIGHT.

5 OPTIONAL W8600F AIR CLEANER MONITOR. M23413

POWER

SUPPLY

2

4

BLACK

BLACK BLACK

BROWN

BLACK

BLACK

WHITE

GREEN

1

3

J4

J5

J1

BLACK

RED

TEST

BUTTON

CONTACT

BOARD

RED IONIZER

BLACK COLLECTOR

5

J8

Contents

Main PRODUCT DATA F300 Electronic Air Cleaner APPLICATION FEATURES Contents ORDERING INFORMATION SPECIFICATIONS Model: Electrical Ratings: Fractional Efficiency: Temperature Ratings: Mounting: Weight: See Table 3. Dimensions: Accessories: Repair Parts: 568-0240EF-5 Fig. 2. Electronic air cleaner installation dimensions in in. (mm). PLANNING THE INSTALLATION Application Review Installation Requirements Applications with Air Conditioning DIM. C (SEE TABLE) DIM. D (SEE TABLE) Applications with a Humidifier Applications with Outdoor Air Intake Optional W8600F Air Cleaner Monitor Optional W8600A AIRWATCH Indicator Choose Location Determine Duct Design Requirements Transitions Turning Vanes Offsets INSTALLATION When Installing this Product... Unpack Electronic Air Cleaner Clean Blower Compartment Fasten Cabinet To Furnace Install Turning Vanes Fasten Cabinet To Ductwork Seal Joints Position Cell Key Attach Cell Handles Reassemble Air Cleaner Complete Wiring OPERATION CHECKOUT Inspect the Installation Check Air Cleaner Operation SERVICE Cleaning the Cells and Prefilters Automatic Dishwasher Washing Cells in a Container Washing Cells at the Car Wash Reinstall the Cells and Prefilters Replacing Media Postfilters Replacing Ionizer Wires Modification to Reduce Ozone Odor Page Fig. 18. Move J5 shorting bar to reduce ozone production about 20 to 25 percent. REPLACEMENT PARTS (TABLE 4)/EXPLODED VIEW (FIG. 19) Page PARTS AND ACCESSORIES NOT ILLUSTRATED (TABLE 5) Page Fig. 20. Troubleshooting Guide. WARNING ELECTRONIC AIR CLEANER TROUBLESHOOTING GUIDE Page DONNES TECHNIQUES Filtre air lectronique F300 APPLICATION CARACTRISTIQUES Table des matires POUR COMMANDER FICHE TECHNIQUE 368-0240EF-5 EFFICACIT ET PERTE DE CHARGE DU FILTRE AIR DIVERS D BITS DAIR SANS POST-FILTRES Fig. 2. Encombrement en mm (po) Installation du filtre air lectronique. 68-0240EF-5 4 Tableau 3. Poids lexpdition et linstallation. Poids 406 x 508 mm (16 x 20 po) 406 x 635 mm (16 x 25 po) 508 x 318 (20 x 12-1/2) PLANIFICATION DE LINSTALLATION Application Vrifier les exigences relatives linstallation Applications appareil de refroidissement Applications humidificateur Choix de la position dinstallation Raccords de gaines requis Raccords de transition Dflecteurs Raccords de drivation INSTALLATION Avant dinstaller ce produit Dballer le filtre air lectronique Nettoyer le compartiment du ventilateur Fixer le botier lappareil de chauffage Installer les dflecteurs Fixer le botier au systme de gaines Sceller les joints Installer la clavette de la cellule dans la bonne direction. Fixer les poignes des cellules Rassembler le filtre air Terminer le raccordement FONCTIONNEMENT VRIFICATION Vrifier linstallation Vrifier le fonctionnement du filtre air MAINTENANCE Nettoyage des cellules et des prfiltres Nettoyage des cellules dans le lave-vaisselle Nettoyage des cellules dans un bac Nettoyage des cellules dans un lave-auto Remise en place des prfiltres et des cellules Remplacement des post-filtres fibres Remplacement des fils dionisation Rduction de lodeur dozone Page 68-0240EF-5 16 PICES DE RECHANGE (TABLEAU 3)/VUE EXPLOSE (FIG. 19). Fig. 19. Composants du filtre air lectronique (illustr: modle deux cellules). PICES ET ACCESSOIRES NON ILLUSTRS (TABLEAU 4) Page 21 68-0240EF-5 AVERTISSEMENT GUIDE DE VRIFICATION-DPANNAGE DU FILTRE AIR AVERTISSEMENT Honeywell