Honeywell HCM-2051 SET UP, FILLING

• Remove the water tank by grasping handle and

pulling straight up (Fig. 1). Set aside.

• Lift up on the motor housing to remove and set aside

(Fig. 2). Remove the Natural Cool Moisture®filter

from the base before filling the unit with water. Soak

filter in a sink full of cool water to help reduce

mineral build up and place back in the humidifier

while wet. DONOT SQUEEZE OR WRING OUT THE

NATURALCOOL MOISTURE®FILTER. To help extend

the life of your filter repeat this step each time you

fill your humidifier.

• Turn the Water Tank upside down so that the Fill Cap

is facing up; unscrew the Fill Cap by turning it

counter-clockwise and set aside.

•

Fill the Water Tank with COOL tap water (Fig. 3).

Distilled water is not necessary as the water is filtered

by the Natural Cool Moisture

filter.

DO NOT USE HOT

WATER.Doing so may damage the humidifier.

•Replace the fill cap by turning it clockwise . DO

NOTOVER TIGHTEN. Turn the Water Tank right-side

up.

NOTE: WHEN CARRYING THE FILLED WATER TANK

PLEASE USE THE HANDLE AND PLACE YOUR OTHER

HAND UNDER THE TANK FOR ADDITIONAL SUPPORT.

NOTE: We recommend that the humidifier be disinfected prior to first use. Please

see CLEANING instructions.

• Select a firm, level, flat location - at least six inches from any wall for proper air flow (Fig.

1). Place the humidifier on a water-resistant surface, as water can damage furniture and

some flooring.

The manufacturer will not accept responsibility for property damage caused by water

spillage

Fig. 1

Fig. 2

Fig. 3

WALL

SET UPFILLING

HCM-2051 OM (eng only) 6/25/01 1:40 PM Page 4