Honeywell HE120 Wall Mounting:

HE120 BY-PASS DRUM HUMIDIFIER

17 69-1860EF—01

5. Unscrew Back Cover of the Humidistat and remove.

See Fig. 39.

Fig. 39. Removing Humidistat Back Cover.

6. Snap two Screw Terminals over the blade terminals on

the Control Assembly. See Fig. 40

Fig. 40. Installing Screw Terminals.

7. Connect the two low voltage control wires to the Screw

Terminals on the Control Assembly. See Fig. 41.

Fig. 41. Wiring Humidistat.

8. Tuck excess wire into the recessed area on the back of

the Base Plate.

9. Use four #6x 1in. Sheet Metal Screws to secure the

assembly to the duct through the mounting holes.

See Fig. 42.

Fig. 42. Securing Humidistat to Duct.

10. Push the Setpoint Dial knob onto the control shaft.

Wall Mounting:

IMPORTANT

Mount the control in an area with average room tem-

perature and relative humidity.

1. Locate the control about 5 ft. above the floor on an

inside wall. See Fig. 43.

Fig. 43. Selecting Humidistat location.

2. Drill a 3/8 in. hole in the wall

3. Run 18-gauge two-strand thermostat wire to the loca-

tion and pull about 6 in. of wire through the hole.

M12841A

CONTROL

ASSEMBLY

SETPOINT

DIAL

GASKET

DUCT

SHEET METAL

SCREWS (4)

5 FEET

[1.5 METERS]

YES NO

M19925