36
Installing UltraKey Lite with VideoBloX
Note In this field, you are setting the VideoBloX NetCPU IP address. To set the
UltraKey Lite IP address or enter the main configuration menus, press Alt >
Clr and see Step 3: Set and Configure for an Ethernet Connection on page 38.
16. Use the numeric keypad to enter an IP address as required,
then press Ent.

Step 4: Configure VideoBloX Mode Default Settings While Powering Up

1. While powering up, when the Time Left 3 menu displays, press Alt > Camera to set
the VideoBlox mode.
2. Set the corresponding serial port as:
Baud Rate: 19.2 KB
Data Bit: 8
Parity: None
Stop Bit: 1
Installing and Configuring an Ethernet Connection
For a list of accessories see Shipping Checklist on page 18 and for port connections and
pin assignments see UltraKey Lite Port Connections and Descriptions on page 19. The
UltraKey Lite Controller runs TCP/IP keyboard protocol.

Step 1: Connect to the UltraKey Lite Ethernet Port

Note The direct RJ45 connection using the Ethernet port is only available with
newer model VideoBloX NetCPU systems.
IP Address
159.099.251.230
Time Left 3