DY-012 SERIES ASSEMBLY INSTRUCTIONS
NOTE: Remove all contents from the box being careful not to discard the manual and hardware needed for assembly. A phillips head screw driver ( 
) is required for assembly and is not included with the fan purchase.
A. Base Assembly
•Gently turn the fan upside down.
•Place the power cord through the recessed channel located in the center of the rear base assembly (Fig 1).
•Align the rear and front base assembly and firmly snap together by pushing the 4 round extrusion into the adjacent circles of the connecting pieces (Fig 2).
B. Securing the Tower Fan to the Base
•Using the 3 (M5 x 12) screws and phillips head screw driver ( 
) secure the base into the bottom portion of the fan housing by aligning the 3 screw holes on the base with the 3 screw holes on the bottom of the fan housing (Fig 3).
•Gently pull any slack out of the power cord and place the cord securely in the power cord
holding bracket (Fig. 4).
•Place the fan right side up. Your fan is now ready
for use.
Fig. 1
Fig. 2
Fig. 4
DY-012 SERIES OPERATION INSTRUCTIONS
• Be sure your fan is in the | Fig. 5 | Fig. 6 | |
OFF position by pressing | |||
|
| ||
the off button. ( ) |
|
|
•Place the fan on a level and dry surface.
•Plug the power cord into a polarized 120 Volt AC wall outlet.
•To operate, press the appropriate speed control
option: High ( 
), Medium ( 
), or Low ( 
) (Fig. 5).
•To activate or disengage the fan oscillation, press the oscillation button ( 
) (Fig 6).
•To turn the fan OFF ( 
) press the Off button once.
