Honeywell HZ-510 important safety instructions Set-Up, Output Direction

HZ-510_OM_Rev1.qxd 6/22/06 10:59 AM Page 2

IMPORTANT SAFETY INSTRUCTIONS REGARDING THE PLUG ON YOUR PRODUCT

Fig. 1

SET-UP

•Place the heater on a firm, level, open surface free from obstructions and at least 3 ft. (0.9m) away from any combustible materials. DO NOT use on an unstable surface such as bedding or deep carpeting. Be sure the heater is not in a position where it may be tripped over by small children or pets. The heater’s rubber feet will hold it firmly in position.

•With the Power knob in the OFF position, plug the heater into a grounded 120V outlet suitable for a 3-prong plug (Fig.1).

OUTPUT DIRECTION

• Turn the Thermostat fully clockwise to its highest position.

This heater is equipped with adjustable front legs that allow you to adjust the heat output angle up and down.

Adjust the angle up or down by turning the lever located on the side of the

heater counter-clockwise to tilt up. Turn the lever clockwise to lower the output angle. (Fig. 2).

Fig. 2