Honeywell LYNXR24 manual HJLQ7LPH, End Time hour, End Time am/pm, End Time minute, End Day, Hjlqd

86(5￿)81&7,216￿

6FKHGXOLQJ￿8VHU￿,QWHUIDFH

￿

	%HJLQ7LPH￿
￿E￿ ￿￿ ￿[[￿		￿@[[@FRQWLXHUHWXUQEHJLQWRSUHYLRXVSURPSWPLQXWH￿WR￿￿
	%HJLQ'D\		• If the value programmed in the Event Identifier is “3”,
[[￿￿￿EG￿	>	FRQWLXHUHWXUQEHJLQGD\WRSUHYLRXVSURPSW￿￿WR￿￿	“4”, or “5”, and the current entry is completed, the
			system will save all field data up to this field. The
			system will beep four times and go back to the first field
			(Schedule Number) with the schedule number
			advanced.
			• If the value programmed in the Event Identifier is “1”
			or “2”, and the current entry is completed, the system
			will advanced to the next programming field - End Time
			(hour).
			NOTE: See figure 2 for the definition of begin day entries.
	End Time (hour)		• The end hour is a two-digit entry. To enter the hour 3,
￿ [[￿￿￿$(￿	[xx] = end hour 00 to 12		press “0” followed by “3”.
	[*] = continue		• The end hour “00” indicates this schedule does not have
	[#] = return to previous prompt		a end time.
	End Time (am/pm)		• Press “0” to select AM or “1” to select PM.
	[0] = end time, am (A)
	[1] = end time, pm (P)
	[*] = continue
	[#] = return to previous prompt
	End Time (minute)
￿￿(￿￿￿ ￿[[￿	[xx] = end minute 0 to 59
	[*] = continue
	[#] = return to previous prompt
	End Day		NOTE: See figure 2 for the definition of end day entries.
￿ [[￿￿￿(G￿	[xx] = end day 01 to 17		• If the event identifier is set to “2” upon completion of
	[*] = continue
	[#] = return to previous prompt		this field, the current schedule data will be saved and
			the system will go back to the next schedule number.
	Device Number		[*] will accept and save the entire schedule event. The
￿[￿ ￿￿￿￿GQ￿	[xx] = device number 1 to 8		system will beep four times and go back to the beginning
	[*] = continue		of the programming field (Schedule Number) with the
	[#] = return to previous prompt		schedule number advanced. If the current schedule
			number is 8, the system will wrap around and set the
			schedule number to 1.
			NOTE: For X-10 devices.

– 30 –