|
| USE & OPERATION |
Touch Screen Control Panel |
| Warning Light |
| (when flashing) | |
|
| |
| STOP |
|
Timer Control |
| Power Control |
Fan Speed Control | Timer / Temperature Set Controls | Mode Control |
| ||
|
|
Power Control
The Power Control turns the unit on and off.
Mode Control
3 settings: Cool, Dehumidify and Fan
A light will indicate which setting is currently being used.
• Cooling Mode 
The unit works as an air conditioner. Adjust fan speed and air temperature to suit your desired comfort level. Temperature setting range is 61°F~89°F.
• Dehumidifying Mode
Air is dehumidified as it passes through the unit, without being in full cooling mode. If room temperature is higher than 77°F
fan speed can be adjusted; otherwise fan speed is preset "LOW".
Note : If the unit will be used mainly as a dehumidifier, do not connect the exhaust hose and let the warm air return in the room. Continuous drainage is then necessary and more efficient (refer page 14, Continuous Draining).
• Fan Mode
For air circulation without cooling.
• Heating Mode 
When heating mode is selected the indicator light will shine. Heating is activated only when the ambient temperature is below 25°C . In this mode, the desired temperature can be set between 16°C and 25°C.
Note: The air exchange hoses must vent outside the room when using heating mode.
Note: unit does not need to be vented in Fan mode.
Fan Speed Control
3 settings: High, Medium and Low.
Timer Control
Auto turn off:
With machine in running mode, press timer button to select the number of hours you want the unit to run in air conditioning mode.
Auto turn on:
With machine in stand by mode, press the timer button to select the number of hours until you want the unit to automatically start running.
Temperature / Timer Set Controls
•Used for adjusting the timer and thermostat.
•The default display is room temperature.
•In cooling mode, when “ ▼ “ or “▲“ button is pressed, the set temperature is displayed and may be adjusted.
After 10 seconds the display will revert back to room temperature. Temperature is only adjustable in cool mode.
The time is adjustable between 1~24 hours.
Note : By pressing both “ ▼ “ / “▲“ set buttons at the same time, the display will toggle between Celsius and Fahrenheit.
Warning Light
Condensed water may accumulate in the unit. If the internal tank becomes full, the Power Light will flash and the unit will not operate until the unit has been drained (refer page 14, Water Condensation Drainage).
After switching the air conditioner off, you must wait 3 minutes before switching it back on again. | 10 |
