INSTALLATION

Full Speed or Low Speed USB (Integrated)

1.Turn off the host device.

2.Plug the male 10-pin RJ45 end of the USB PowerLink cable into the 10-pin socket on the MS3780.

3.Plug the other end of the USB interface cable into the host device’s USB port.

4.Turn on the host device.

Figure 11.

As a default, the MS3780-38 leaves the factory with USB Keyboard Emulation Mode enabled.

For information on configuring the MS3780-38 for USB Serial Emulation Mode, please refer to the USB: Low Speed section of the MetroSelect Configuration Guide (PN 00-02407).

When the scanner first receives power the white LED will flash, one blue LED will turn on and the scanner will emit one beep.

Plugging the scanner into the USB port of the PC does not guarantee that scanned information will appear at the PC. A software driver and correct configuration setting are also required for proper communication to occur.

See Caution statement on page 5.

11