Honeywell ST 3000 manual 84

A.6

Configuring Smart Meter Using SFC, Continued

Transmitter Output

• You can set both the lower and upper display limits when you

Conformity and Smart

have selected custom engineering units (Custom) and the

Meter Configuration,

transmitter output conformity is set to LINEAR.

continued

When setting the lower and upper display limits, if you let either

the lower or upper display limit setting time out (after thirty

seconds), the meter will discard the newly set values and will

revert to its previous settings. The meter forces you to set both

limits by automatically initiating the next limit setting, either

lower or upper, depending upon which limit you set first.

3. If you change the transmitter’s output conformity, you must

reconfigure the smart meter as outlined in Table A-9.

After making any adjustments to the smart meter, keep the transmitter

ATTENTION

powered for at least 30 seconds so that the new meter configuration is

written to non-volatile memory. If power is turned off before 30

seconds, the changes may not be saved so that when the transmitter

power is restored, the meter configuration will revert to the previous

settings.

Procedure

The procedure in Table A-9 outlines the steps for setting up the

configuration for a smart meter using an SFC.

Table A-9

Setting Up Smart Meter Configuration Using an SFC

Step

Press Key

Read Display or Action

Description

1

Calls up first configuration prompt.

B

S

T

C

O

N

F

I

G

CONF

C

O

N

F

O

R

M

I

T

Y

?

2

Calls up next configuration prompt.

H

S

T

C

O

N

F

I

G

NEXT

M

e

t

e

r

C

o

n

f

i

g

?

Prompt asks if you want to access

meter configuration function. If you

want to access it, go to Step 3. If

you do not want to access it, press

[CLR] key to exit function or [▲ NEXT]

key to call up next configuration

parameter.

Continued on next page

74 ST 3000 Release 300 Installation Guide 2/05