Programming Thermostat
Initial Powerup
When the thermostat is first powered up (or after eight hours of continuous power loss), the display blinks for two seconds and then undergoes a
This is followed by the display flashing (1:00 PM); the internal checkout is complete and the thermostat is ready to be programmed.
To verify that the thermostat is turning on the baseboard heater, press the (+) key until the setpoint displayed exceeds the room temperature.
The (°) symbol is flashing. Feel for warmth in the area close to the heating element; the unit should be starting to generate heat.
Press and hold the Prog key to return the thermostat to the Run mode.
Factory Set Programming
The thermostat defaults to a normal non- programmable thermostat at
Table 1. Preset Factory Schedule
for 7-days.
|
|
|
Event | Time | Temperature |
|
|
|
|
|
|
WAKE | 6:00 AM | 70°F (21°C) |
|
|
|
LEAVE | 8:00 AM | 61°F (16°C) |
|
|
|
RETURN | 6:00 PM | 70°F (21°C) |
|
|
|
SLEEP | 10:00 PM | 61°F (16°C) |
|
|
|
5 |