Honeywell T8601, T8602 owner manual View or ResetTimer Settings, Honeywell, ZqLI Pl, u P! IP

Honeywell

T8600,T8601,T8602,T8611,T8624 Thermostats

FURNACE AIR FILTER, HUMIDIFIER PADAND ULTRAVIOLET(UV) LAMP

TIMERS

The thermostat has up to three timers to help the homeowner remember when to change or clean the furnace air filter, whole-house humidifier pad or ultraviolet air treatment system UV lamp. See Table 1.

		Table	1.	Thermostat			timers.
							Type of	Thermostat
Timer Measurement		Manual		System		Switches		Pusbbutton		System Keys
			(Heat,		Off,	Cool)			(Heat,	Off, Cool)
Calendar	days in any mode.	Furnace air	filter		and	UV	lamp timers	UV lamp	timer
Calendar	days in Heat mode only.	Humidifier	pad	timer				Humidifier	pad	timer
System run time in any mode.					--			Furnace	air filter timer

View or ResetTimer Settings

When the thermostat activates a timer, the thermostat flashes Filter until the timer resets.

1.Reset the timer by pressing the i key until the expired timer is displayed.

3.Press the Run Program key.

NOTE: You can view the number of days remaining at

any time by pressing the i key three or four times. If more than one timer is active, ell active

u P! IP--

FilterDays

2.Press the Time Akey to reset the timer.

timers show sequentially when pressing the i key several times.

For complete instructions on replacing or cleaning your furnace filter, humidifer pad or UV lamp, see the product owner's manuals. Contact your local contractor or visit www.bonewveli.com/vourhome.

For instructions on entering installer Setup mode, see product installation instructions (installers only). Table 2 gives installer Setup instructions for the timers.

ZqLI Pl !_--

FilterDays

M2(1244

® US. Registered Trademark

Copyright @ 2002 Honeywell • _ *All Rights Reserved (_9- [ 5 _4- [