– 28 –
Macro Key Programming & Usage (cont’d)
The keypad beeps to acknowledge your inpu t and displays the command you
entered (followed by “F”).
4. En ter the next command, followed by press/holdin g the “D” key for at least two
seconds. The keypad beeps and displays the keystrokes entered so far.
5. Repe at until all the desired commands (up to 16 characters inc luding the “F”s)
have been entered.
Be sure to check your keystrokes before continuing. If you made a mistake, you
must start over.
6. To exit, press/hold the “D” key for at least two seconds. The display returns to
system status and indicates system is re ady.
Example of Macro Programming
Suppose you want to (1) bypass the two upstairs window
zones, then (2) turn on an exterior ligh t, and then (3) arm
the security system in the AWAY m ode. The procedures
in the table that follows show you how you would
program this macro:
Typical Macro Alpha Display:
MACRO PGM
60203F#701F2F
Function Keystrokes Required Keypad Display
1. Bypass zones 02 & 03 Press BYPASS [6] key, then
2-digit zone numbers 02 & 03.
60203
2. Insert terminator Press the “D” key for at least 2 seconds. 60203F
3. Turn light on
(device 01) Press [#] and 7 key for “device ON”, and
[01] key for selecting device 1.
60203F#701
4. Insert terminator Press the “D” key for at least 2 seconds. 60203F#701F
5. Arm system AWAY Press AWAY [2] key. 60203F#701F2
6. Insert terminator Press the “D” key for at least 2 seconds. 60203F#701F2F
7. Exit Macro Mode Press the “D” key again
Using a Programmed Macro Key
∗∗∗∗DISARMED∗∗∗∗
READY TO ARM
1. Press the Macro key programmed for the desired
series of commands for at least 2 secon ds. The “Enter
User Code” prompt appears. The prompt remains
displayed for up to 30 seconds.
ENTER USER CODE
∗ ∗ ∗ ∗
2. Enter your 4-digit security code.
The p rogrammed macro sequence begin s
automatically after the user code is enter ed.