Arming Perimeter Only
(With Entry Delay ON)
Using the 3 STAY key
Use this key when you are staying home, but might expect someone to use the entrance door later.
When armed in STAY mode, the system will sound an alarm if a protected door or window is opened, but you may otherwise move freely throughout the premises. Late arrivals can enter through the entrance door without causing an alarm, but they must disarm the system within the entry delay period or an alarm will occur.
The system provides three STAY modes. STAY mode 1, 2, and 3. STAY modes 1 and 2, when activated, automatically bypass specific zones assigned by the your installer to each of the STAY modes. STAY mode 3, when activated, automatically bypasses all zones assigned to STAY modes 1 AND
2.Check with your installer for a list of the zones that are bypassed during each STAY mode.
Close all perimeter windows and doors before arming (see CHECKING FOR OPEN ZONES section)
STAY
1. Enter your security code and press
3
+
1 for STAY Mode 1.
Enter your security code and press
3
+
2 for STAY Mode 2.
Enter your security code and press
3
+
3 for STAY Mode 3.
NOTE: If none of the zones in a partition are assigned to Stay mode 2, then when the user enters [User Code] + [3] (STAY), all zones assigned to Stay mode 1 are automatically bypassed.
2.
ARMED ***STAY 1*
ZONE BYPASSED
The keypad beeps three times, displays the armed message, and indicates which STAY mode (1, 2 or 3).
Note: "ZONE BYPASSED" in this display simply indicates that some zones of protection are not armed when using STAY mode.
– 36 –
