CHANGING BELT OR BRUSHES
1 | 2 | IMPORTANT: Switch cleaner off and |
|
| remove plug from electricity supply |
|
| before checking the brushes or removing |
|
| hood. |
If your cleaner is not picking up efficiently, the belt or brushes (or both) may need replacing, but first make sure you have:
•Emptied the dust container
•Cleaned filters
•Checked for blockages
B
1
A
Remove hood
•Prise off the carpet care control selector
•Remove hood screws A and B.
•Lift off hood
2
Remove brush assembly
•Inspect belt for signs of wear.
•To remove, pull brush cleaner assembly upwards out of cleaner housing. Remove belt from motor spindle then from brush assembly.
Replace belt
• Loop the new belt around the motor spindle then |
around the brush channel. |
* Features vary according to model |
3 | Refit brush assembly | |
• Hold the brush assembly | ||
| ||
| and stretch the belt until | |
| brush mountings slot down | |
| ||
| into the cleaner housing. | |
| Rotate the brush to ensure | |
| free movement of the belt. | |
|
|
4 | Refit hood | |
• Refit hood, ensuring the | ||
| ||
| lugs along the front of hood | |
| are located in the slots | |
| along the front edge of | |
| baseplate. | |
| • Secure hood, using screws | |
| A and B. |
5 | Refit carpet care control | |
selector | ||
| ||
| • Ensure the raised face (T) | |
| is towards the front of the | |
| cleaner. |
Removing a blockage from the Pet Hair & Allergen Remover* (Certain models only)
Open clip and lift cover to remove blockage.
CLEARING A BLOCKAGE
!IMPORTANT: Switch the cleaner off and remove the plug from the electricity supply before dismantling cleaner.
This cleaner is unlikely to become blocked, except by over filling of the dust container or accidentally picking up large solid objects. Clearing a blockage is simple.
If cleaning tools were in use, check cleaning tool and exten- sion tube first. Next check hose handgrip; to remove grip ribbed ring as shown, turn in direction of arrow and ease apart.
To check the hose, stretch it to full length and switch on the cleaner; the suction will dis- lodge most obstructions. If this is unsuccessful, switch off and unplug the cleaner. Remove the hose by turning it anti- clockwise as shown. Detach cassette and remove blockage.
For blockages in cleaner base:
1. Turn the cleaner over and check that the brushes are free to rotate.
2. Check for a blockage in hose socket. Use a piece of wire or a blunt flexible rod to remove any obstructions.
- -
28/11/2007 15:43:28
