Hoover 4080 manual Hepa Pre-motor Filter Model VCC-07 only

5. DIRT CONTAINER (CONTINUED)

2.Lift out the full dust bag Fig.6/2

3.Dispose the full dust bag and insert a new dust bag into the vacuum cleaner. Align the

front of the dust bag with the air entrance.

NOTE: The seal ring around the dust bag opening should cover

the air entrance connector Fig.6/2 inside the housing.

Pre-motor Filter (Model VCC-05 only)

1.	Turn off the vacuum cleaner
	and unplug it from the electrical
	outlet.
2.	Unclip the retainer clip on the
	top of the vacuum cleaner and
	lift up to gain access to the dirt
	container department. (Fig.6/3)
3.	The pre-motor filter is found in	Fig.6/4
	the centre of the dirt container.
	Rotate the filter retaining disc
	anti-clockwise to gain access to
	the filter (Fig.6/4).
4.	The pre-motor filter can be lifted
	out. (Fig.6/5)
	NOTE: Vax recommends
	replacing the premotor filter
	when it becomes discoloured.
5.	Replace with a new filter inside	Fig.6/6

	and turn the retaining disc
8	clockwise to secure. (Fig.6/6)

Fig.6/3

Fig.6/5

HEPA Pre-motor Filter (Model VCC-07 only)

1.Turn off the vacuum cleaner and unplug it from the electrical outlet.

2.Unclip the retainer clip on the top of the vacuum cleaner and lift up to gain access to the dirt container department (Fig.6/8).

3.The HEPA pre-motor filter is found in the centre of the dirt container. Rotate the filter clockwise to remove (Fig.6/9).

4.Gently tap the filter against the side of the rubbish bin to remove excess dirt. The filter may then be rinsed in cool water. Allow to thoroughly air dry before replacing. Replace the filter every 3-6 months depending on usage or when the filter becomes discoloured (Fig.6/7).

NOTE: Do NOT use any detergents or boiling water to wash the filter.

5.Replace the HEPA filter back in the machine before use.

9