Hoover 56511A46 ON-OFF switch, Cord clip, Handle positions Transporting cleaner, Carry handle

ON-OFF switch

Plug cord into electrical outlet.

To turn cleaner ON, push switch (A) toward front of cleaner.

To turn cleaner OFF, push switch toward back of cleaner.

2.2

A

Cord clip

To help keep the cord out of the way while vacuum- ing, position cord down into cord clip (B) located between top cord hook and handle.

2.3

B

Handle positions

Transporting cleaner

The handle of your cleaner has three positions; upright for storage and when using cleaning tools; operating position for general operation on carpet and floors; low for reaching under low furniture. Step on handle release lever to lower handle.

2.4

To move your cleaner from		2.5
room to room, put handle
in upright position,	tilt
cleaner back on	rear
wheels and push forward.

Carry handle

The cleaner can also be moved by using the carry handle.

2.6

Embedded DirtFINDER™

(Available on select models only)

With red and green lights (A),					2.7
the	‘DirtFINDER’			system
alerts the user to areas of
carpet that may need more					A B
cleaning attention. It is able
to	sense		when	larger
amounts		of	dirt particles,
especially		embedded dirt,
are removed.

To let you know that the DirtFINDER™ feature is ready, the red light will come

on when the cleaner is first turned on. After a few seconds, the red light will go off and the green light will come on. Cleaning may then begin.

The green light will remain on throughout cleaning except when the detector senses that a larger amount of dirt is being picked up; then the red light will come on.

When the red light is on, you should take additional cleaning strokes in the area until it changes to green.

•The red light may seldom come on during cleaning. This means that your cleaner is picking up primarily fine surface dust and lint which the system may not detect, or that the carpet is generally clean. To increase the feature’s sensitivity to dirt, set the switch (B) to the “Hi” position.

•At other times, the red light may stay on for a considerable amount of time. This means that the carpet contains a high level of dirt which is being removed by the cleaner. To decrease the feature’s sensitivity to dirt, set the switch to the “Reg” (Regular) position.

7