The Control Panel
Door Lock
Indicator
Programme | Spin Speed | Digital | Wash Time | ||||||
Selector | Selector | Display |
| Selector | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Sensitive | Temperature Start/Pause | |
Care | Selector | Button |
Stain | Delay | Easy |
Blaster | Start | Iron |
Turning the Machine On
Turning the Programme Selector to your chosen programme will turn the machine on. The Programme Selector must be returned to the OFF position between each wash cycle in order to reset the controls.
Start Pause Button
START
After selecting the programme and the required options press the Start Pause button once to start the wash cycle. There will be a short time delay to the start of the programme while the machine sets the wash parameters for the selected programme and options. The Door Locked and KG Mode indicator lights will also illuminate a few seconds after pressing the Start Pause button.
PAUSE
The programme may be paused at any time during the wash cycle by holding down the Start Pause button for about two seconds. The door locked indicator light will remain illuminated for approximately 2 minutes. The door can be opened when this indicator goes out. To restart the programme, press the Start Pause button once again.
Cancelling and Changing the Programme
To cancel the programme the Programme Selector should be rotated to the OFF position. Select a new programme and start as detailed above.
Digital Display
The
Wash Cycle Time/ |
|
Delay Start Indicator | Kg Mode |
Spin Speed | Wash Length |
Indicator | Indicator |
Door Locked | Wash Temperature |
Indicator | Indicator |
Wash Temperature
When a programme is selected the relevant indicator will light up to show the recommended wash temperature. You can select a different temperature by pressing the Temperature button. For example: The Cottons programme will default to 40°C.
With this control the temperature can be reduced to 30°C to reduce energy consumption or increased to 60°C for a more intensive wash.
Today, most detergents have been improved to wash efficiently at lower temperatures, therefore we have set the default temperature settings of each programme to a lower level, saving electricity and reducing the carbon footprint of your machine.
Please refer to the Programme Guide for the maximum temperature to which each programme can be set.
Door Locked indicator
The Door Locked indicator light is illuminated when the door is fully closed and the machine is ON.
When Start Pause is pressed on the machine with the door closed the indicator will flash momentarily and then illuminate. If the door is not closed the indicator will continue to flash. A special safety device prevents the door from being opened immediately after the end of the cycle. Wait for 2 minutes after the wash cycle has finished and the door locked light has gone out before opening the door. As a safety measure, check that there is no water evident in the drum. At the end of the cycle turn the programme selector to OFF.
If the programme is paused, the door locked indicator will go out after 2 minutes and the door can be opened. Check there is no water evident in the drum before opening the door.
16 | 17 |