Battery Fuel Gauge: Battery Capacity Indicator Information

All three LEDS will momentarily light when the product’s power switch is turned on. Then the Battery Fuel Gauge will
indicate the pack’s remaining capacity as noted below. NOTE: Unit and lights will turn off when battery is fully discharged.
Once battery is fully discharged return switch to off position.
3 LEDs lit Remaining batter y capacity > 75%
2 LEDs lit Remaining batter y capacity > 50%
For belt replacement, please call 1-800 -944-9200 or visit our website at ww w.hoover.com to locate
a dealer nearest you. Belt Ser vice Part # 001942002
4. BATTERY FUEL GAUGE, DISPOSAL & SERVICE

Battery Disposal

WARNING:RISKOFEXPLOSIONOREXPOSURETOTOXICMATERIAL
CAUTION:The batt ery used in this dev ice may pres ent a risk of fire or chemical burn if mi streated. Do not
disassemble, heat above manufacturer’s maximum temperature limit (60˚C/140˚F), or incinerate. Replace battery
with HOOVER®® battery Part # BH50000 only. Use of another battery may present a risk of fire or explosion.
Dispose of used batte ry promptly. Keep away from children. Do not d isassemble and do n ot dispose of in fi re.
Do not attempt to disassemble the battery or remove any component project ing from the battery termin als. The
battery and ch arger have no user serviceab le parts. Fire or injury may result. Prior to disposal, protect exposed
terminals with heavy insulating tape to prevent shorting.
1 LED lit Remaining battery ca pacity > 25%
1 LED blinking Remaining battery capacity < 25%

Baffle Tube Removal and Replacement

Belt and Brushroll Replacement

REMOVA L
Hold dirt cup right side up and
press bottom release button to
open trap door.
Turn baffle tube counter
clockwise until it stops. Pull out
baffle tube, hold over trash can
and shake free debris.
REPLACEMENT
To replace baffle tube, insert
back into dirt cup, align slots
and twist clockwise till tube
locks in place.

3.11 3 .12 3 .13

3.14

Dirt Cup and Filter Replacement

REPLACEMENT
Insert filter into filter cap.
Insert filter cap into dirt cup. Place bottom of dirt cup onto
housing and pivot into place until
dirt cup release button locks.

3.8 3.9 3.10

WARNING: Remove battery before servicing.
Turn vacuum nozzle over. Remove screws indicated by arrows on
bottom nozzle plate. Lift plate off nozzle bottom to access brush, belt
and nozzle.
After replacement turn brushroll making sure belt turns freely.
Return nozzle plate and screws.