How to use
Before you begin cleaning
a. Vacuum thoroughly - For carpet, use a vacuum cleaner with an agitator for best results. Vacuum upholstery with a vacuum cleaner with cleaning tool attachments. Use a crevice tool to reach into tufts and folds. Do not use the‘SteamVac Jr.’ compact spot cleaner as a dry vacuum cleaner.
b. For upholstery, check cleaning code - Use your ‘SteamVac Jr.’ compact spot cleaner only if the upholstery fabric is marked with a “W” (for “wet” clean) or “S/W” (for “solvent/dry” or “wet” clean). Do not clean fabric marked “S” (“solvent/dry” clean only). If your upholstery does not have a code, seek professional assistance.
c. Test for colorfastness - Mix detergent and water accord- ing to the instructions under "How to fill solution tank." Wet a white absorbent cloth with the solution. In a small, hidden area, gently rub the surface with the dampened cloth. Wait ten minutes and check for color removal or bleed with white paper towel or cloth. If surface has more than one color, check all colors.
d. Pretreat spots with HOOVER® PreCleaner* - Test PreCleaner for colorfastness by first spraying it on a hidden area; wait ten minutes and blot with white paper towels or cloth.
If no color change is visible, spray PreCleaner onto spots. Wait at least ten minutes. Use your ‘SteamVac Jr.’ compact spot cleaner to pick up PreCleaner and spot. Repeat until spot is removed; carefully scrub with a household scrub brush if necessary . Do not saturate carpet or upholstery with PreCleaner.
No cleaning solution removes all stains from all carpets. Stain removal varies with the type of spill, time elapsed before removal, carpet material and carpet type.
*Available at additional cost if not included with your model. (Can also be ordered from the Purchase Envelope enclosed with this cleaner.)
How to fill solution tank
Disconnect cleaner from electrical outlet.
FILL CAP
FILL
PORTFULL
CAPACITY
1/2
CAPACITY
Remove fill cap. For a full tank of cleaning solution, pour 2 oz. of detergent into tank through fill port and fill tank to “full capacity” line (1/2 gallon) with hot tap water.
For a half tank, use 1 oz. of detergent and fill tank to “1/2 capacity line” (1 quart).
ON/OFF switch
OFF
ON
Plug cleaner into a properly grounded outlet.
Push switch forward to turn cleaner on. Pull switch backward to turn cleaner off.
How to empty recovery tank
When the recovery tank is full of dirty solution, the automatic
Turn cleaner off and disconnect from electrical outlet.
POUR
SPOUT
Empty tank by pouring dirty solution from pour spout.
Note: Check the recovery tank often and empty it when it appears full even if the automatic
Automatic “shut-off”
RED FLOAT DISC
FILTER
When the recovery tank is full, the automatic
When this happens, the red float disk will rise to the top of the cleaner lid (see illustration). The cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch.
Continued ➜
3