
Note: we recommend you keep the screws to immobilise the machine for future transit.
The Manufacturers will not be responsible for any possible damage to the machine caused by not following the rules relating to releasing the mechanism. The user is responsible for all costs of installation.
Water connectionThe appliance must be connected to the water mains using new
The old
The machine has an inlet hose with 3/4" B.S.P threaded end connection to attach between the threaded connector on the appliance and the cold water supply.
This machine only uses cold water, therefore only one hose is needed to connect to the cold water supply. Do not connect to the hot supply. Cold fill is an energy efficient system. Only the water required for the washing is heated.There is no loss of heat in the pipeline from a hot water tank or boiler to the machine.
| min 4 cm | |
cm | +2,6 mt max | |
100 | ||
max 85 cm | ||
max | ||
| min 50 cm |
Note: it is advisable to turn off the tap after each wash to isolate the washing machine from the water supply.
For the washing machine to function properly the terminal end of the discharge hose (mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the ground.
ELECTRICAL CONNECTIONSAfter installation, the appliance must be positioned so that the plug is accessible. If the plug we supply does not fit
CUT IT OFF AND DESTROY IT!
You can’t use it on other appliances, and the exposed wires could be dangerous if plugged in. To fit a replacement plug, proceed as follows:
Connect | to the terminal in the plug |
| |||||||||
green and yellow wire | marked with the letter E, |
| |||||||||
| OR marked |
| |||||||||
| with the symbol, |
|
|
|
|
|
|
| |||
| OR coloured green, |
|
|
|
|
| |||||
|
|
|
|
|
| ||||||
|
|
|
|
|
| ||||||
| OR coloured green and yellow. |
| |||||||||
blue wire | marked N |
| |||||||||
| OR coloured black. |
| |||||||||
brown wire | marked L |
| |||||||||
| OR coloured red. |
|
WARNING
This appliance must be earthed
Fuses and plugs
This appliance should be used only on a socket with a minimum rating of 13 Amp.
Our
If the fuse cover is lost, do not use the plug until it is replaced. A correct replacement fuse cover (obtainable from your local retailer) must be the same colour as shown or named on the insert on the base of the plug.
34 | 35 |