DESCRIPTION OF THE CONTROL PANEL
PROGRAMME SELECTION AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)
IMPORTANT
The dishwasher has two very practical functions:
- the "recommended" programme |
(which is ideal for full load daily use) |
for quick and accurate selection; |
- the "Auto’ Memory", function saves |
any programme used at least 3 times |
Programme interruption
Opening the door when a programme is running is not recommended especially during the main wash and final hot rinse phases. However, if the door is opened while a programme is running (for example, to add dishes) the machine stops automatically.
Close the door, without pressing any buttons. The cycle will start from where it left off.
WARNING!
F G H I
consecutively, so that if you regularly |
use the same washing cycle you |
do not have to continually set the |
programme thereby saving time and |
effort. |
If you open the door during the drying cycle, an audible audio signal advises you that the drying cycle has not yet finished.
E D C
A "ON/OFF" button
B PROGRAMME DESCRIPTION
C "PROGRAMME" buttons
D "HALF LOAD" option button
E "DELAY START" button
BA
F "PROGRAMME STATUS" lights / "DELAY START" time lights
G "OPTION SELECTION" light
H "PROGRAMME SELECTION" lights I "SALT EMPTY" light
Programme settings
■ Open the door and place the dirty dishes | |
inside the appliance. |
|
■ Press the "ON/OFF" button | . |
■ After pressing the "ON/OFF" | button, |
the indicator light which is factory set | |
"recommended”, or the indicator light | |
for the "Auto’ Memory" programme will | |
flash. |
|
■ If you wish to select an option, press the | |
Changing a running programme
Proceed as follows to change or cancel a running program:
■ Open the door. |
■ Hold down the current programme button |
(with the indicator light on) for at least 5 |
seconds. The programme indicator lights |
(except for the "RAPID" programme |
indicator light) will flash. |
■ The running programme will be cancelled |
and the indicator light for the |
“recommended” programme or the |
DIMENSIONS:
Height | cm | 82 ÷ 88,5 |
Depth | cm | 55 |
Width | cm | 59,8 |
Depth with door open | cm | 117 |
|
|
|
TECHNICAL DATA:
EN 50242 place load | 15 |
Capacity with pans and dishes | 9 persons |
Water supply pressure | Min. 0,08 - Max 0,8 MPa |
Fuse | (see rating plate) |
Power input | (see rating plate) |
Supply voltage | (see rating plate) |
option button (the corresponding indicator |
light will light up). |
The option button can be selected or |
deselected WITHIN 2 minutes of the |
programme commencing. |
■ Choose a programme by pressing the |
corresponding button. |
■ Close the door (after an audible signal |
has sounded, the programme will start |
automatically). |
IMPORTANT
To select the "COLD RINSE" programme, simultaneously press the "RAPID" programme button and "HALF LOAD" option button.
indicator light for the programme that was used at least 3 times consecutively will start to flash.
■At this point a new programme can be set.
IMPORTANT
To cancel the "COLD RINSE" programme, simultaneously hold down the "RAPID" programme button and "HALF LOAD" option button.
WARNING!
Before starting a new programme, you should check that there is still detergent in the dispenser.
If necessary, top up the dispenser.
20 | 21 |