AUTOMATIC FAULT SIGNALS
FAULTS | CAUSE | SOLUTION |
|
|
|
E2 appears on the display and | No water (inlet hose closed). | Turn off the dishwasher, open the |
the alarm sounds. |
| inlet hose and reset the cycle. |
|
|
|
E3 appears on the display and | The machine cannot drain water. | Check if the drain tube is bent or if |
the alarm sounds. |
| the siphon or filters are clogged. |
|
| If the problem persists, contact |
|
| Customer Service. |
|
|
|
E4 appears on the display and | Water leak | Check if the drain tube is bent or if |
the alarm sounds. |
| the siphon or filters are clogged. |
|
| If the problem persists, contact |
|
| Customer Service. |
|
|
|
E5,E6,E7,Ef or EL appears | Electronic control fault. | Contact Customer Service. |
on the display and the alarm |
|
|
sounds. |
|
|
|
|
|
E8 or Ei appear on the display | The water heating element is not | Clean the filter plate. |
and the alarm sounds. | working correctly or the filter plate is | If the problem persists, contact |
| clogged. | Customer Service. |
|
|
|
WATERCONTROL-SYSTEM
The
In the
This fault is shown by a red sector on the window «A». Would this occur, please refer to your Service Agent.
If the hose is not long enough for correct connection, it must be replaced with a longer one. The hose can be obtained from your Service Agent.
Safety antitwist device (press and twist to remove the washer)
A
Red button blocked valve indicator
24 | 25 |