INSTALLATION

(Technical notes)

■After unpacking, adjust the height of the dishwasher. For the dishwasher to work correctly it must be level. Adjust the feet so that the machine does not tilt by more than 2 degrees.

■If it you need to move the machine after removing the packaging, do not try to lift it by the bottom of the door. Follow the

instructions in the figure. Open the door slightly and lift the machine by holding on the top.

IMPORTANT

When the appliance is located on a carpet floor, attention must be paid to ensure that there is no obstruction to the bottom vents.

Make sure that the plug on the appliance remains accessible after installation.

Water connection

IMPORTANT

The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused.

■The inlet and drain hoses can be directed to left or right.

IMPORTANT

The dishwasher can be connected to either cold or hot water, as long as it is no hotter than 60 °C.

■ Water pressure must be between

0,08 MPa and 0,8 MPa. If the pressure is

below the minimum consult our service

department for advice.

■ The inlet hose must be connected to a

tap so that the water supply can be cut

1

2

Electrical connection

Plug your dishwasher into the power socket.

If the plug we supply does not fit :

■CUT IT OFF AND DESTROY IT!

You can't use it on other appliances, and the exposed wires could be dangerous if anyone plugged it in.

■Fit a suitable plug, as follows:

WARNING!
THIS APPLIANCE MUST BE EARTHED.
Fuses and plugs

This appliance should be used only on a socket with a minimum rating of 13 Amp.

Our ready-fitted plug is already equipped with a 13 amp fuse which is BS 1362 ASTA approved.

Any replacement should be exactly the same.

off when the machine is not in use

(fig. 1 B).

■ The dishwasher is fitted with 3/4" threaded

connector (fig. 2).

■ Connect inlet hose “A” to water tap “B”

with a 3/4" attachment making sure that

it has been properly tightened.

■ If it is necessary, the inlet pipe can be

lengthened up to 2,5 m. The extension

pipe is available from the After Sales

Service Centre.

3

Connect
to the terminal in the plug

If the fuse cover is lost, do not use the plug until it is replaced.

■ If limescale deposits or sand are present

in the water, it is advisable to obtain the

Green and

Marked with the letter E,

OR marked with the Earth symbol,

A correct replacement fuse cover (obtainable from your dealer or Electricity board) must be the same colour as shown or named on the insert on the base of the plug.

appropriate filter, art. 9226085, from the

After Sales Service Centre (fig. 3). The

filter “D” must be inserted between the tap

“B” and the inlet hose “A” , remembering

yellow wire OR coloured green,

OR coloured green and yellow.

Manufacturer declines all responsibility for any damage due to non-earthing of the machine.

to fit the washer “C” .

■ If the dishwasher is connected to new

pipes or to pipes which have not been in

use for a long time run water through for

Blue wire

Marked N,

OR coloured black.

Appliance complies with European Directives 73/23/EEC

a few minutes before connecting the

inlet hose. In this way no deposits of

sand or rust will clog up the water inflow

filter.

Brown wire

Marked L,

OR coloured red.

and 89/336/EEC, replaced by 2006/95/EC and 2004/108/EC, and subsequent amendments.

4

5